Xoutpost.com

Xoutpost.com (https://xoutpost.com/forums.php)
-   X5 (E53) Forum (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/)
-   -   Please Help!! Cant get started after cut out! (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/96867-please-help-cant-get-started-after-cut-out.html)

radaudiodesigns 04-26-2014 02:22 PM

Please Help!! Cant get started after cut out!
 
Hi Guys, New to the forum!
Looking for your advice in diagnosing a starting problem with my 2004 E53 X5 3.0D.
The car recently had the turbo replaced, and I’ve done about 30 miles since it came out of the garage – all around town. I went to give it a run down the motorway, and as I got onto the on-ramp the car lost all acceleration and I rolled to a stop on the side of the on ramp and the car cut out. It would not restart and was towed back home.
First thing I did was change the battery, as after trying to crank a few times, it would die. Unfortunately, this hasn’t solved the starting problem.
Next I removed the glove box to try and locate the fuel pump relay – as I couldn’t hear the fuel pump priming, but I can’t seem to locate it (See below picture) any advice on location would be great.
I also lifted the rear seat and checked voltage to the fuel pump – this showed as 0V….
The car is cranking strong, but won’t fire – I don’t think fuel is getting to the front.
I’ve also noticed that the 4x4 light is illuminated constantly, and there is also no power to the air con centre console, which used to come on at ignition 2. Finally I’ve noticed that the whirry fan noise that used to come on when I unlocked the car with the remote is not coming on either.
I’ve plugged in my code reader and get the following – which I believe is just related to the electronic issue of fuel being sent to the front (which would explain why the car cut out).
4321 – Delivery Control Valve
4351 – Rail Pressure Control Valve
41A2 – Charge Air-Pressure Controller
4BC2 – Air Mass Flow Sensor
4822 – A/C Capacity Output
4BC7 – Intake Air temperature sensor
4203 – Glow Control Unit
3EC0 – Camshaft Sensor
3EC1 – Camshaft Sensor
Really appreciate any input, as I’m really at a loss.


To Recap –
* No power to fuel pump & can’t hear when ignition 2
* 4x4 light on constantly
* Cannot locate fuel pump relay – Can you see in pic?
* No Power to the heater console


Cheers




http://s7.postimg.org/rils7b9nv/20140426_155445.jpg
http://s7.postimg.org/ept2tn8ob/20140426_155454.jpg
http://s7.postimg.org/o1jq4caln/20140426_160544.jpg
http://s7.postimg.org/4fzulvxkb/20140426_160553.jpg
http://s7.postimg.org/bkhnux4tn/20140426_160909.jpg
[img]http://s7.postimg.org/4aw3c7q97/20140426_160927.jpg[/img]

X5SND 04-26-2014 03:02 PM

Im not sure if its the same on a diesel, but the fuel pump relay is normally located ON TOP of the fuse panel. You actually have to take the 4 torx out on the fuse panel to drop it down. Relay should be a green one in the corner.

danp 04-26-2014 05:10 PM

4x4 - try turning steering wheel lock to lock to reset. Likely due to recent work.

You have an 04 same year as mine, check the relay but for the year it may very well be the pump. I changed mine a couple months ago after similar no start issues. It was pretty easy.

Inform the shop of the lack of heat at center console not certain but they may have neglected to plug it in if they were in there.

powers1 04-27-2014 08:04 AM

Double post!!!Op already created same thread here and received an adequate reply!!
http://www.xoutpost.com/bmw-sav-foru...r-cut-out.html


All times are GMT -4. The time now is 09:09 AM.

vBulletin, Copyright 2026, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved.