Xoutpost.com - X5 4.6is Engine Block from 4.4

Xoutpost.com (https://xoutpost.com/forums.php)

- X5 (E53) Forum (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/)

- - X5 4.6is Engine Block from 4.4 (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/97769-x5-4-6is-engine-block-4-4-a.html)

Quote:

Originally Posted by Nick P (Post 1002821)

JE pistons are made for iron sleeves you can't use them in alusil block (or you have to coat the stock pistons with ferrostane or similar material), but there's no need to sleeve the block - you can just bore it out from 92 to 93 mm and re-use the old pistins with new piston rings - it's much much cheaper, than putting the sleeves and new pistons.

1 mm bigger bore costs here in Europe about 600-700 Euro for 8 cylinders, a used 4.4 block is about 200-300 Euro max. a set of new piston rings is something like 150 Euros. Thats it!

If you bore the block out, you will need to get the bore re-alusil or nikasiled.

Quote:

Originally Posted by BRABUSBENZ21 (Post 1002866)

If you bore the block out, you will need to get the bore re-alusil or nikasiled.

I already wrote something about it in the post #5

Alusil is a material (the whole block is made of alusil), nikasil is a coating - in case of alusil you'll just need to use special bursting (not exactly a hone) to disclose the silicon crystals in aluminium matrix, but it's an easy routine process being performed daily.

Quote:

Originally Posted by Nick P (Post 1002821)

ic. Will speak to my machine shop about this. Also, I just managed to buy a 4.6 block from ebay that had a 2-3mm chip between cylinders 1 & 2. My machine shop said in the worst case, they can fill it out and fit sleeves to those 2 cylinders. This will be a safer bet than using the 4.4 block I guess.

ebay link to block: 02 03 BMW E53 x5 4 6IS Engine Block 98K Miles | eBay