dis help needed bad
 

hello to all
got my gt-1 cable/software all is install i can read the codes in inpa or erase them but when i try dis i can read anything error about no connection and something about no enable adapter with ip 192.168.68found any help with this would be more than appreciated. thanks

Do you have ifhsrv32.exe running? Is API test passing? Actually to make it easier to help you, I'd suggest you mention what you did to setup DIS, if you configured it, how you're running it etc. This way it would be easier to pinpoint your issue or missteps and help you out!

ok got it working here is what to do hope it helps other.
go to Start -> Run and type 'ncpa.cpl' without quotes and press enter, in the Network Connections window right click on Vmnet1 and select Properties, double click on 'Internet Protocol TCP/IP' or 'Internet Protocol v4' and check the box "Obtain an Ip address automatically" and click OK, do the same for VMnet8.

ok tested the abs all 4 sensors show same number for each sensor module bad
steering sensor ok

now i just need info on how to reset adaptation for MAF suspect it might be on its way out
at start up reads 20kgh and warm idle 17kgh 39kgh at around 2500rpm