Thank you for your time. Get to it when you can and it will be appreciated whenever that is.

Okay. Here is the "print & cut" pattern for the organizer. Be sure to print the image at Actual Size on 11 x 17 paper. To check print size, the 1X part should be 11-1/8" long along top edge (slots) and the 2X pattern should be 6" long along top edge (away from slot). A little more or less is okay. The foam core does compress a little when pushed into the console.

Material: I used 1/4" thick black foam board from a craft store. Be sure to buy enough material for all three parts and make sure that the sheet is large enough to fit the large 1X piece.

Tips: Use a very sharp razor or Exacto blade and cut using a very shallow angle. Almost parallel to the material. This will produce the cleanest edge. If you cut with an upright blade angle, you can pull and tear the core material and the cut edges will have an uneven finish. You can see some of this in the pictures above.

I made the slots narrower than 1/4" so the interlocking pieces would fit snuggly. The foam core will compress slightly to fit into the slots with a little wiggly and patience.

Best of luck and please provide feedback and modifications you added.

The X console seem to be "just right" here in TX.....

TiAgX5, I would concur that is a properly organized TX center console.

Thanks.

Just the right size for my back-up gun and 4 speedloaders.