INPA error
 

Alright ladies and gentlemen, I’m stumped...

I’m trying to avoid the costly “guess and check” method with parts.
I scanned with INPA and have no error codes at all. I have a manifold gauge set and the pressure shows plenty high enough.

I scanned the analog values during startup and shut down.
The things I noted as “odd” are the clamp 30 voltage shows around 8-9v, the right side temp sensor fluctuates up to 20-40c during start and stop, but after a few seconds of “hunting” it sticks at 0degC and doesn’t move.
I’m not sure what the lsv-motor value should be either... but I’m guessing the value it shows isn’t right.


Anyone have INPA that can share some snapshots of their analog values to assist me in tracing the culprit?


Thanks in advance!

Uh, you do know that is not an appropriate way to assess freon fill, correct?

Have someone evac, measure, leak test, refill to specified and add leak detection fluid.

Then see how it runs.

Prolly cost you 100-200.

Or you can F around for a few weeks.

My 2 cents