Pedal install question
 

My aluminum pedals came from Bimmian yesterday. One of the screw holes doesn't go all the way through on the gas pedal. It does have the recess so the screw head sits flush when installed but that's as far as it goes. There is also a recess on the underside of the pedal. Can it be drilled through or do I need to return it?

TIA

You should be able to drill it w/o any problems.

One note:
The screws for the gas pedal are too long. They will prevent the pedal from going all the way down. So you will need to finder shorter screws or cut about 1/4" off the existing ones. Just be careful not to damage the thread, or cut them off after you install them.

Thank you!