quad tips?
 

I have an '11 x5 50i with m package. I want to change the exhaust and get quad tips put on. I found a remus exhaust with square tips. Bimmian sells different tips that will fit the outlet exhaust diameter and are quads. My local garage is telling me it can't be done without cutting the bumper while Bimmian says it will fit into my bumper as is...can anyone confirm one way or the other who is right?

Anyone else done this? Seems unlikely that it can't be done without chopping up the bumper.

I have found these https://www.bimmian.com/Remus-Clamp-...for-BMW-E70-X5 for my 08 x5 3.0si want to do the same thing

That's the ones. The garage I was asking to do my exhaust swears they won't fit into the bumper, Bimmian insists they will.

I have these
 

I have the stock 50i tips for sale and these quad tips for sale. No modifying of bumper, just weld t any muffler shop...

either set $150 shipped anywhere in the States.

Egis, great look! Very clean. Could you take a pic what the fit looks like behind the bumper? Do you have to cut the originals off or do these replace the existing tips only.

I really like the black quads, my e70 is met. black and i think that the black ones would look good.

that's not my truck, I found it by going through google search. These are from bimmian.

Oops, sorry. That white truck looks good.

I will have to do abit of investigating because I dont like the round singles on my 35d.

when they state 89mm (~3.5in), is that the diameter? Not sure how that applies to the dual exhausts.

It says the dual tips are 84mm which about 3 3/8"
The singles are 98mm which is roughly 3 7/8"

my woman has the 2006 e53 and wants to change up the tips. anyone know what will fit?


Sent from my iPad using Tapatalk

Any guesses if the large singles will work on a 2011 3.0l X5 with factory rounds (singles)?


I'll do the legwork if I can be educated on what/ where to measure.

Im sure it fits. You'll just have to cut the plastic trim with a dremmel tool. or have the muffler shop do it.

Thank you!

just did mine, they look to be coming further out then they really do.
i bought the OEM retrofit bezels.
this is a non Msport bumper though
https://fbcdn-sphotos-b-a.akamaihd.n...01264435_o.jpg
https://scontent-b.xx.fbcdn.net/hpho...30283467_o.jpg

Do you have a link to where you bought the tips
 

I like them

Thanks

Alex

Quad tips
 

The quads I went with are here.

Black Powder Coated Exhaust Muffler Tip Dual Round Forward Slash Cut Rolled Edge 2.25" Inlet / ID, 3" Outlet / OD, 9.5" Length. 6.25" Outer Width #RTP-037BLR

It definitely takes some work to get them in there, but they were what I was looking for.

Also I have a set of the stock 4.8 exhaust tips if anyone is interested.