View Single Post
  #2  
Old 06-25-2019, 01:01 PM
RRPhil RRPhil is offline
Member
 
Join Date: Jan 2011
Location: Blackburn UK
Posts: 417
RRPhil is on a distinguished road
If all the proportional solenoids are functioning correctly on your Mechatronic unit then resetting the adaptions is unlikely to cause an issue.

However, one of the most common problems with the 6HP26 is faulty solenoids. If you have one or more dodgy solenoids then the controller may have already set the adaptions for those solenoids to the extreme value for the range available to it. If you then reset the adaptions back to ‘nominal’ it’s possible that the controller will not learn the new adaptions in time before the clutches controlled by those solenoids burn themselves out. This is particularly likely to occur if this is done at the same time as a fluid change as the clutches may also need to learn a new friction coefficient, especially if the wrong fluid is used which has a different friction modifier pack.

For that reason, it’s recommended that you should only reset the adaptions if you have either replaced the solenoids, or the Mechatronic unit, or possibly had the Mechatronic firmware updated.

https://xoutpost.com/1094585-post2.html

Phil
Reply With Quote

Sponsored Links