Ok, so I finally pulled the alternator and had it tested by a certified recycler. 100% good.
Oddly, as I was pulling the alternation I noticed the connector was good and tight but the push in locking clip was missing. I have a replacement clip not a perfect fit but if I bend it a bit should work. Don’t think it’s the problem but the rebuilder said the alternator had been worked on at some point so I assume whoever reinstalled lost the clip and didn’t say anything about it…..
I’ll put it back together and see if I can get the clip to work, then move on if it’s not the problem..
Thanks.
Sent from my iPad using Tapatalk
|