Quote:
Originally Posted by HPIA4v2
Mine start doing it but I am lazy to check, been too busy.
But, I believe you need to adjust the trunk stops, on each side; this allows the trunk to pop out a bit more so the latch doesn't catch to relock.
I assume you have no corosion on the electronic of trunk latch.
BTW, what year is yours? just curious.
|
OK I checked and my first hunch was correct, the trunk stops needed adjustment.
So here are the pictures I took, very easy less than 5 min job; use torx 25 to loosen the rubber stop then twist CCW until it's about 34mm, both sides. Make sure it's not too far out more than 36mm, then you'll likely get trunk lid not close message cause it won't latch securely. Now I can press the button from inside and the trunk stays open.