Hi.

I replaced both my sensors on the rear wheels recently..

I was fortunate enough to not have any problems getting the bolts out, since they where nice and loose..

However, both the sensors caused some problem, getting them out. The plastic which the sensor is made of, was brittled, and they broke apart when i tried to pull them out..

I used wd-40 and worked the sensor around to loosen them.. Plenty of Wd-40.

On side, i got it loose enough to pull it out by the wire, on the other side, the wires broke, and what finally solved it, was to screw a phillips head screw into the sensor which was still in the hole, and by pulling and wriggeling, it came loose and out...

Very satsified when i got it out, but i was worried for a while that pieces would be stuck in there..

I was also worried about pieces breaking of the sensor falling into the hole where the sensor is situated..

Could this cause problems later on..? I guess there is no way out of there, exept the one hole.??