I am trying to benchtest a bordmonitor but I cannot figure out if it's required an iBus message or it should power up if I only connect it to power.
On the car doesn't seem to work and going by the connectors pinout I should be able to power it on by applying ground on pin 2 and +12V on pin 7 and 11 on the blue connector. Although by in the pinout pin 11 is the switched 12V when I measured it on the car harness this pin 11 is not populated. That makes me think that I need an iBus message to get the bordmonotor powered up.
Any thoughts?
