Coding car memory options

[LVP]

Hi guys,

I tried to change a few options in the car memory. Specifically
- remove the auto lock after you start driving
- remove the tilt steering adjust when you turn the car on/off

I went in with DISv44 and could access the options and make the changes. I set the changes and it seemed to take, but they haven't. Now when I go to redo the same changes, it's as if I'm making no changes and it won't go through the setting of the change. Am I missing a step somewhere? By it telling me I'm not making changes, means to me the changes are there somewhere. Do I have to do anything with the key or cycling of power to get the changes to activate?

I basically did these steps and my screens matched those in this post.
http://www.xoutpost.com/589197-post35.html

Thanks in advance.

P.S. I know I can connect, as I did the transfer case reset and it auto-ID's the vehicle. I tried before without the proper cable and it wouldn't even give me the menus or the options to change.

[LVP]

Tried it all again, but applied the opposite setting for each option (then re-applied to get them set again). Seems to be something in the on/off key toggling that does it. Screen pops up and says "turn off/on". I do that and hit yes and it pops the same screen again. Next I turn key off, press yes, it accepts the settings and I turn the key on again and it sticks. Seems a bit weird, but whatever, steering wheel doesn't move now and the locks don't apply every time I drive away.