How to install Predator Ice?

[jaba]

Just wanted to know how to install the predator ice i got today. where do the black wires go to? where to the red wires go to? Do i have to use them all. Can i get help on where to start? I'm an electronic numbskull. Thanks

[jlevi]

It's very simple:



JL

[jlevi]

By the way, please provide us with photos of your successful install?
JL

[jaba]

I just got the t taps today cause i didn't get any from the package that you sent.

Before working on it,I would just like to make sure that using these t-taps on my stock harness won't cut or damage the wires. I want to make sure i can bring things back to it's original configuration in case something goes wrong with my head light. (warranty concern)

If i get a reply from you that all is good to go, then I will post pictures as soon as i get things done. Thank You.

[jlevi]

It will make a small slit in the wire sheathing but will NOT cut the wire at all. You will be able to revert back to stock 100%
JL

[jaba]

Can't seem to fit the predator ice inside the hole. Tried both predator ice and none of them fit. Kinda frustrating. Any solutions?

[loansinpa]

I just put mine in today, they do fit tight...as they should. I looked at the way the original bulb came out and matched up the direction/placement notches so I at least had an idea where to start with the new one.

[X5Jay]

Originally Posted by loansinpa

I just put mine in today, they do fit tight...as they should. I looked at the way the original bulb came out and matched up the direction/placement notches so I at least had an idea where to start with the new one.

So how do they look? Are they bright?

[jlevi]

It's a tight fit
JL

[loansinpa]

As requested...photos. I forgot to mention, this was in my 540 not my x5 but results are still the same...much brighter. The last pic is the old bulb but if you're paying attention when you take it out you can see where the tabs line up to put the new one in.