Set The Universal Garage Opener

[michko]

Ok, I've read the manual on how to set the garage door opener but it's not happening.

I have a rolling code garage door unit so I did exactly what the book said......clear the three buttons........press the button on the garage door unit to send out the signal.....and then press the button on the universal remote three times and nothing.

When you press it three times, do u hold it down on the third time? or?

Very frustrating.

Anyone that can shed some light on this would be great.

Thanks

[Wagner]

Press Homelink in the car and hold till light flashes, you've just cleared any codes.

Click the button on your garage door opener unit itself to send out a signal.

Click the garage door opener button (the hand held deal you would have in your car) and hold it down while simultaneously hitting the Homelink button in your car.

[vern]

Originally Posted by michko

Ok, I've read the manual on how to set the garage door opener but it's not happening.

I have a rolling code garage door unit so I did exactly what the book said......clear the three buttons........press the button on the garage door unit to send out the signal.....and then press the button on the universal remote three times and nothing.

When you press it three times, do u hold it down on the third time? or?

Very frustrating.

Anyone that can shed some light on this would be great.

Thanks

I had the same problem when I got my 530i. I called HomeLink at 1-800-355-3515 and they talked me thru the process and everything worked fne.
Good luck
cheers
vern

[LeMansX5]

Rolling codes openers are not easy. Check this article or call toll free # above.
http://www.xoutpost.com/articles/x3/e...ogramming.html

[E46Pilot]

I have a Chamberlin Opener, my wifes X3 2007, I had to press the learning button on the garage door opener unit itself then run into the car and press and hold the button I wanted to be programmed.

[AzNMpower32]

Go onto the Homelink site itself. They have clearer instructions there under Garage Door Openers.

[x52006]

I tried programming my x5 for the first time but did not know about the homelink site. Will try there instructions today, thx guys.

[statdoc]

Originally Posted by AzNMpower32

Go onto the Homelink site itself. They have clearer instructions there under Garage Door Openers.

No, the article I wrote that is on the X5World Home Page is a copy of the Homelink material. I specifically highlighted the info that they DON'T make available to cursory searching. It was only after great effort, and desperation, that I found and tried what worked with my X5 and wife's Mercedes.

Carry on.

[vern]

Had a problem with someone having the same frequency that I have to open the garage door. They would open the garage door in the middle of the night and I wouldn't know about it until the next morning when I went outside. This happen twice, I was lucky they didn't steal any thing. Any way I have a Sears opener with rolling code so I cleared all the remotes and had to start over to get them to work. I just used the learning button on the control to program them and everything worked out fine the first time around. You press the button and you have 30 seconds to program each remote. Problem solved, I hope.
cheers
vern