Winter maintenance project 4.6is

[bcredliner]

This is the group of parts that are recommended to be replaced.

https://www.ecstuning.com/News/BMW_E...003/ES2526336/

[jontezan]

Originally Posted by bcredliner

This is the group of parts that are recommended to be replaced.

https://www.ecstuning.com/News/BMW_E...003/ES2526336/

Thx, that seems like the parts i bought, im replacing waterpump aswell👍😄


Skickat från min iPhone med Tapatalk

[jontezan]

Originally Posted by X53Jay4.8is

Not necessary to remove vanos unless you have the vanos noise problem

Ok, does the vanos triggerplates need to come of to re-time the units before i put on the new chain? I rather ask alot of stupid questions, than pulling this appart again 😄


Skickat från min iPhone med Tapatalk

[X53Jay4.8is]

Originally Posted by jontezan

Ok, does the vanos triggerplates need to come of to re-time the units before i put on the new chain? I rather ask alot of stupid questions, than pulling this appart again 😄


Skickat från min iPhone med Tapatalk

I would review the Beisan vanos repair procedures/instructions. They are well laid out and of course you do not have to do all of the instructions since you are not doing a vanos repair. Off of the top of my head I dont think you have to remove vanos camshaft sensor trigger wheel. Your just doing the timing chain and guides. Give it a read through. Very informative.

Beisan Systems - Procedures - M62TU Vanos Procedure

[bcredliner]

Have you seen this video series?

https://www.youtube.com/watch?v=bGmni3iTkhk

[jontezan]

Originally Posted by bcredliner

Have you seen this video series?

https://www.youtube.com/watch?v=bGmni3iTkhk

Thanks! Alot of good info 😄


Skickat från min iPhone med Tapatalk

[jontezan]

Originally Posted by X53Jay4.8is

I would review the Beisan vanos repair procedures/instructions. They are well laid out and of course you do not have to do all of the instructions since you are not doing a vanos repair. Off of the top of my head I dont think you have to remove vanos camshaft sensor trigger wheel. Your just doing the timing chain and guides. Give it a read through. Very informative.



Beisan Systems - Procedures - M62TU Vanos Procedure

Thanks for info! They had a pretty nice guide 😄


Skickat från min iPhone med Tapatalk

[jontezan]

Left of here for today. Need to buy a set of 1/2 inch socket torxes, i only have 3/4 at home. Think i will brake them when unbolting the exhaust camshaft sprocket. And once again, i really appretiate the help i get from you guys 😄👍


Skickat från min iPhone med Tapatalk

[X53Jay4.8is]

Originally Posted by jontezan

Left of here for today. Need to buy a set of 1/2 inch socket torxes, i only have 3/4 at home. Think i will brake them when unbolting the exhaust camshaft sprocket. And once again, i really appretiate the help i get from you guys 😄👍


Skickat från min iPhone med Tapatalk

Yes make sure you get a good set of 1/2 inch spline sockets. The factory has them torqued and locked down well.

[jontezan]

Found this in bmw tis. Seems that you are taking a chance that the vanoses are fully retarded to the left. I am going to break all 4 camsprockets free, seems that it is nessecery to get away all chainslack when timing the engine 😄


Skickat från min iPhone med Tapatalk