Quote:
Originally Posted by Scott ZHP
Which one sheared, the one that's drilled through, or the one that's blind?
There's just enough room for the one that's drilled through to fit a half-height hardened nut on the top side and still clear the halfshaft.
|
It's the bolt that goes all the way through with just a thread or so out the top.
Looks like enough room for a full size nut to me, but that's with the wheel unloaded. I'm sure clearance will change considerably with weight on the wheel.
Plan of attack this weekend after it's on the bench.
1. Short Prayer
2. Reverse drill bill small hole
3. Easy out
4. Weld nut on top side of bolt protruding through top of knuckle and try to remove bolt
5. Drill out and re thread.
6. Drill through and install a new 10.9 bolt and 1/2 size nut.
01-05-2017, 10:30 PM
Threaded Mode
