Stereo system

[Silberman]

Thank you for this. Are these from the White connector shown in the picture attached?

Originally Posted by Zulu95

BMW MID Wiring Connections.
1 Ground
2 Terminal 30 12V+
3 Terminal 58 illumination
4 I/K-bus signal link
5 Not used
6 Not used
7 Not used
8 Terminal R 12V+
9 Not used
10 Not used
11 Not used
12 Not used

[semcoinc]

I installed an Eonon GA6166 in my factory NAV, non-DSP E53.



See video clip here

https://youtu.be/RAv0qZusgBQ



And posts regarding my install here at post #167

https://xoutpost.com/bmw-sav-forums/...radios-17.html

and a speaker upgrade was completed with help from this thread:

https://xoutpost.com/bmw-sav-forums/...-speakers.html

Mike

[gatojurko]

How is the sound and radio signal? My micro sd slots are not working anymore
Main features are ok!

[semcoinc]

Originally Posted by gatojurko

How is the sound and radio signal? My micro sd slots are not working anymore
Main features are ok!

My system is working fine and the radio reception is very good.

Here is my final mounting solution that is holding up well. The top two screws do not hold the unit securely in the OE frame opening. The weight of the unit cantilevered at the top causes the bottom edge to kick out over time



Mike

[gatojurko]

That is why I will get new one with 9" straight screen with 32 GB memory!
Why u have so terrible TPMS button??? From where?

[Silberman]

Originally Posted by gatojurko

How is the sound and radio signal? My micro sd slots are not working anymore
Main features are ok!

I forgot to mention the FM signal is good enough, AM signal nothing, very very faint on the strongest stations. Thought of changing out the antenna signal amplifier but not sure if that will affect AM.
Reception was an issue with Original head unit, but I could get a few AM stations.

[wpoll]

Originally Posted by Silberman

I forgot to mention the FM signal is good enough, AM signal nothing, very very faint on the strongest stations. Thought of changing out the antenna signal amplifier but not sure if that will affect AM.
Reception was an issue with Original head unit, but I could get a few AM stations.

Sounds like you have an issue with your diversity reception module - its a powered unit in the rear tail gate - checked the trunk fuses?

[wpoll]

Originally Posted by Silberman

Thank you for this. Are these from the White connector shown in the picture attached?

Looks correct but hard to tell without more connector in the picture. Does that white connector fit the MID and is it as the rear of the car (trunk, left side)?

[wpoll]

Originally Posted by gatojurko

Is this connection to reset clock through BC on steering? I can not imagine how to reset it now...if u have to do it via factory screen which is gone now I have big clock on navi screen and I do not use that small dasboard line anyway

No BC operation - its re-installing the MID unit in the car to give you the reset and set functions back. You need a factory MID unit for this and you can mount it in the rear AV rack in trunk, left side. The factory NAV unit won't work for this.

You could source a used MID unit from eBay...

[Silberman]

Originally Posted by wpoll

Looks correct but hard to tell without more connector in the picture. Does that white connector fit the MID and is it as the rear of the car (trunk, left side)?

That is suppose to be a picture of the white 12 pin plug that goes into the Nav unit in dash.