Badly Need Help w/ HID!!

[eddii]

ok, i tried to use pin 11 from light switch as my trigger "on" to light relay and it doesnt work . it basically forces pin 11 to go back to the same voltage as pin 2 cause it is connected to the light relay coil, hence no light (same as position 0.

there's got to be at least someone here that has done a main beam halogen to aftermarket hid conversion to their cars. i'd reeaally appreciate your input

[drex]

eddii--

what is the voltage on pin 11 in position 0,1,2?

please list the values.

please list the values with switch in position 0,1,2 for pin 2 as well.

expect 0 or 11-12 volts.

if you can give this information, i'm sure we can help you out.

drex

[eddii]

Pin 11

Position 0 = 0V
Position 1 = 0V
Position 2 = 12V

Pin 2

No change in voltage at all = 0V

These were tested with the ignition switched on