Help needed Exhaust manifold

[Henrym3]

Try thIs


Remove centre silencer.
Remove reinforcement plate.
Attention!
The job item "Removing and installing bracing plate" contains important installation notes.
Protect anti-roll bar from paintwork damage.

Remove the retaining bracket and rubber mount from the anti-roll bar.
Release anti-roll bar link on the left and right from the anti-roll bar.

Note:
The oxygen sensors risk being damaged when the exhaust manifolds are removed and installed.

Remove both front oxygen sensors.

Remove cover for fuel injectors.
Note:
Do not mix up the monitoring oxygen sensor for cylinders 1 to 3 and 4 to 6 on the plug connection to the wiring harness.
Mark plug connections.
Unclip the cable from the holder. Disconnect plug connection. Unclip cable on rear side of engine from cable routing.

Remove monitoring oxygen sensors.

Note:
The rear exhaust manifold with catalytic converter is possible only after removal of the front exhaust manifold with catalytic converter.

Remove front exhaust manifold with catalytic converter.
Remove rear exhaust manifold with catalytic converter.
Installation note:
Clean sealing surfaces, replace gasket.
Coat threads with CRC copper paste.
Replace nuts.


Sent from my iPad using Xoutpost.com