Dreaded trans. Failsafe prog.

[Oldmactech]

Ok, progress.

Reconnected all the wires. Soldered some, butt connected others. Tested the connections. All good.

Fired it up, Trans is good, O2’s good. Still have ABS, DSC lights on but for another day.

Not entirely happy with the wiring runs so I will likely redo a little of it but calling it done.

Thanks for all the help and patience. A good time was had.


Sent from my iPad using Tapatalk

[andrewwynn]

Abs won't clear until you drive clear all codes and double check LEW module (separate module for only the steering angle sensitive m sensor). You have to clear sas error though that module.

[TheFixer]

Yeah... the lew probably needs a recalibrate. You'll see when you run inpa or PA soft what is causing it.

My Christmas lights were due to a worn out transfer case motor gear. Cheap plastic that gets chewed up real easy. I bought a brass one to replace it.

https://www.autohausaz.com/pn/UR-27102413711PRM

Then also oil abrasion. Just change your transfer case fluid. To clear that one though you need ista.

[andrewwynn]

Or foxwell scanner.


Sent from my iPhone using Tapatalk Pro

[Oldmactech]

Update 2: dressed up a couple of wires I wasn’t satisfied with, put all the wires where they belong off the exhaust manifolds.

Fired it up, ran fine, no CEL, drove about 30 ft and the ABS/DSC/bRAKE lights went out.

Happy as crap!

Thanks all.


Sent from my iPad using Tapatalk

[andrewwynn]

Well that's just fantastic news


Sent from my iPhone using Tapatalk Pro

[EODguy]

Awesome news!!!


Sent from my SM-A730F using Tapatalk