|
Xoutpost server transfer and maintenance is occurring.... |
Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
![]() |
|
LinkBack | Thread Tools | Display Modes |
#1
|
||||
|
||||
E53 Gone Loco ***SOLVED***
![]() It started a week ago with the rear wiper just accepting the command but wuld not stop with one swipe and would eventually park incorrectly. My Avin radio would just start adding its own commands switching modes from radio, video, bluetooth, etc. Now, my seat heaters won't work but the steering wheel heater does. The front wipers might work, they might not. It seems like the iBus is scrambling messages but that is only a guess. I tried scanning with my Foxwell NT-510 and I can get into the car but I cant access several modules. Can any of our brain trust members on our forum guide me in a direction to check? This one has me baffled ![]()
__________________
Digital Competition Systems The older I get... The faster I was... No Fear ![]() Last edited by Overboost; 10-07-2025 at 01:07 PM. |
Sponsored Links | |
|
#2
|
|||
|
|||
That's frustrating for sure.
Electronics being what they are, have you tried disconnecting then reconnecting the battery?
__________________
04 X5 3.0i auto 03 X5 4.6is |
#3
|
||||
|
||||
Quote:
![]()
__________________
Digital Competition Systems The older I get... The faster I was... No Fear ![]() |
#4
|
||||
|
||||
Quote:
![]()
__________________
Digital Competition Systems The older I get... The faster I was... No Fear ![]() |
#5
|
||||
|
||||
It's reminding me of a shorted oil level sensor knocking out the buss.
Pull the rubber boot out of its mount holes going to the rear hatch. I think there might be two but look first at the right side. The wire bundle in there will commonly self destruct. Mine had a few wires with the insulation rubbed off. Can't read modules is a suck start point because the first step i recommend is look for shorted switches with the foxwell. My rear hatch switch would short when it rained. I would see it on foxwell as "pressed". Can you get to no modules or just some? Typically when a problem it won't read the VIN and you have to manually enter model. Often you can get places you otherwise can't when you go that route. –awr– Using Tapatalk VIP on iPhone
__________________
2011 E70 • N55 (me) 2012 E70 • N63 (wife) |
#6
|
|||
|
|||
Why don't you rule out a bad ignition switch with the visor test...
Start the car, then lower the visor and open/close the vanity mirror a few times. Try it on both visors. If any of your symptoms trigger during the test, replace the ignition switch. Apparently the visor and the switch are on the same circuit.
__________________
'03 530i - manual swapped - 425k miles '06 325Cic auto 115k '05 X5 3.0 auto 158k '99 E39 528i 5-speed 130k |
#7
|
||||
|
||||
Set if you can get to the modules that control the items you described.
There's a good chance you can command rear wiper on for example. If that works you likely have a problem with the switch but if the same module runs seat heat and wipers, leans toward that module. Ever get water intrusion? –awr– Using Tapatalk VIP on iPhone
__________________
2011 E70 • N55 (me) 2012 E70 • N63 (wife) |
#8
|
||||
|
||||
Quote:
![]()
__________________
Digital Competition Systems The older I get... The faster I was... No Fear ![]() |
#9
|
||||
|
||||
Quote:
__________________
Digital Competition Systems The older I get... The faster I was... No Fear ![]() |
#10
|
|||
|
|||
Get a new ignition switch, it is inexpensive.
Use only BMW Genuine ignition switch.
__________________
1998 E39 528i 5sp MT 2006 E53 X5 3.0 6sp MT |
![]() |
Bookmarks |
|
|
|