|
||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Facelift tail light conversion
Thanks |
| Sponsored Links | |
|
|
|
|
#2
|
|||
|
|||
|
you know for the life of me i cannot tell what changed to the rear of the x5?? the front is obvious ... but the rear?!
__________________
MARC/CROSVS | UCLA Bruin, B.A. Econ, Aug 2004 | J.D., Thomas Jefferson School of Law, May 2008 -- MEMBER: California State Bar, December 4, 2008 2005 BMW 645 Cabrio | Black Sapphire Metallic, Ti trim | 6AT | fully loaded sans HUD 2000 Ford Mustang V6 | laser red on tan | 5-spd | track-prepped |
|
#3
|
|||
|
|||
|
Quote:
|
|
#4
|
||||
|
||||
|
The newer model features adaptive braking taillights. It has an extra bulb that illuminates under hard braking. Otherwise they are almost identical. If you park an '00-'03 X5 next to an '04-06' X5, you wouldn't see the differences in the taillights unless you were specifically looking for them. The lens of the new light is a little bit of a brighter red and perhaps a little clearer in the clear portion, otherwise they look identical.
|
|
#5
|
|||
|
|||
|
ah, interesting ....... well thank you for that
__________________
MARC/CROSVS | UCLA Bruin, B.A. Econ, Aug 2004 | J.D., Thomas Jefferson School of Law, May 2008 -- MEMBER: California State Bar, December 4, 2008 2005 BMW 645 Cabrio | Black Sapphire Metallic, Ti trim | 6AT | fully loaded sans HUD 2000 Ford Mustang V6 | laser red on tan | 5-spd | track-prepped |
|
#6
|
||||
|
||||
|
Quote:
|
|
#7
|
|||
|
|||
|
Quote:
|
|
#8
|
||||
|
||||
|
See item 19 in the LIGHTING section of the X5world home page for instructions on this conversion.
__________________
![]() Xoutpost.com - where you come for the information but stay for the friendships |
|
#9
|
||||
|
||||
|
I did this mod about a week ago. Just trim the little black vertical pieces of plastic (about 1/4 inch piece) above the wiring harness connector on the new tails (you'll see the part that iterferes with the install if u try to put the new tails in). Put them in with the same 3 screws you removed from the old ones and your done,
|
![]() |
| Bookmarks |
|
|
|
|