X-5 Battery Drain

[Morristown BMW]

Shifter light NOT on: (battery fully charged)
Find the ground cable on the battery, but do not disconnect.
(the cable end connected to the body not the battery, is easier to handle.)
Connect the Positive lead from the “Fluke” to the body of the car (good ground)
Connect the Negative lead to the (brown) ground cable (you can puncture it)
Make sure it’s easy to disconnect the (brown) cable from the body, but don’t
take it off yet.
Open the glove box and remove and disable the switch so the light will not turn on, locate the fuse box.
Start the car and run at idle, turn EVERYTHING on, and activate
all the components (sunroof, windows, a/c, lights …..) run 5 min.
turn the car off and remove the key. Open all doors and trunk, and with a screw driver,
close the door locks so the system thinks all doors and the trunk is closed.
Now lock the vehicle with the remote.
The “Fluke” must be set up to “A” not “mA” otherwise you will blow the
fuse in the meter. Remove the nut from the ground cable and remove the cable from the stud. You meter will indicate around (300mA).
Let the car go to sleep. (16 min) minimum, if this is not happening start over.
After the sleep mode is on the draw should not be more then 50mA, if it’s more
go to the glove box and start puling fuses one by one and check the draw after each one, but do NOT re-install the fuse. Pull the fuse and leave it out
There are some fuses under the right cover in the trunk. If you pull a fuse and car wakes up start over (next time ignore this fuse). If you pull a fuse and the draw drops to around 50mA, read the label on the fuse, you will know witch circuit is faulty.
Let me know the fuse # and I will look up the diagram to see what is on that circuit.

Steve