|
Xoutpost server transfer and maintenance is occurring.... |
Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
|
LinkBack | Thread Tools | Display Modes |
#91
|
|||
|
|||
Dubs |
Sponsored Links | |
|
#92
|
||||
|
||||
you said that the camera has a light for the license plate - did you pop the lens cover off the license plate light? does that camera fit in the space available?
i am not so sure about the current flow on the coils of those relays - the one with resistor shunts some of the current - the reason i am so picky about current is due to the fact that the coils are tapped into other circuitry not designed for additional flow of current... that is why i am using relay with 37.5 mA coil amperage. there is another one, for 17 ma, which would be better, but i was too lazy to find one... the 37.5 mA was bought at a Radio Shack... there is a spec sheet in previous posts... |
#93
|
|||
|
|||
Quote:
Yellow plug is for Camera out ..... feeding picture to your Screen. Black plug is to power Camera. There should be another plug that come separate with the camera, plug that into the black plug, the other is just small Red/Black wires, again, just + & -
__________________
13.6 Street tire Gtst 11.6 Street tire R32 GTR |
#94
|
|||
|
|||
Quote:
__________________
13.6 Street tire Gtst 11.6 Street tire R32 GTR |
#95
|
|||
|
|||
Quote:
You will need to remember ..... The Relay acts as a middle man. It takes Reverse signal from your reverse light, then allow the negative current (any neg) to flow through to the White wire that came with your Reverse Cam Harness that you bought on Ebay so that the screen can jump over to the reverse cam mode.
__________________
13.6 Street tire Gtst 11.6 Street tire R32 GTR |
#96
|
|||
|
|||
Did digital TV came with your car as a standard option?
__________________
13.6 Street tire Gtst 11.6 Street tire R32 GTR |
#97
|
|||
|
|||
Yes it did, thanks for the replies too
Dubs |
#98
|
||||
|
||||
is your camera "plug-n-play" for the license plate light opening? Or, you need to modify something?
|
#99
|
|||
|
|||
Ok, SUPER close now, I wired it up to the relay as advised and the cam switches properly when put into reverse.
Now it's flickering madly when the engine is on and slowly flickering when the engine is off but in reverse with accessories on. Any advice? Dubs |
#100
|
|||
|
|||
Re-reading, when I say as advised I mean as per the picture of the relay with the wires labelled that's earlier in the thread.
This may be wrong in reading post 80 by Ty. Dubs |
Bookmarks |
|
|
|