Strange Problem

[jlegendre]

Just installed Dice silverline (works great) very happy to finally get it installed. I followed the directions that were posted here: http://www.bavariansoundwerks.com/pr...d-Kit-by-DICE/

Great install PDF and videos. EAS really needs to get some better install information on their site. Anyway, as part of the install you remove the driver's seat which is very simple to remove two nuts in the front of the seat and two bolts in the back. It came out no problem. Well when I went to put the seat back one of the bolts in the rear would not go back in all the way? Yes, I made sure I put them back as they came out, then I tried switching them. Both bolts work in the left hole but neither work in the right? It goes about half way and then will not go any further. Both bolts look fine, not stripped or anything.

Has anyone ever experienced this? I'm about do for an oil change so I was goin to have the dealer take a look.

Secondly, does anyone think this is a major safety issue that I should have addressed immediately? The bolt is in half way in (just enough for the seat to pass over it on it's rail thank goodness). Does anyone think this is a dangerous way to be driving?