|
Xoutpost server transfer and maintenance is occurring.... |
Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
DVD Headrest installation - How did you run the wires?
Thanks. |
Sponsored Links | |
|
#2
|
||||
|
||||
the best way would be to unbolt the seats and run the wires under the carpet where the two sections meet under the seats and rout the cabling through the center console to the other side. possibly enough room to mount the control box under the center console, if not just wire tie it to the underside of one of the seats. but remove the back of both seats in order to run the wires up to the headrest
__________________
Robert 1994 740iL 2001 X5 4.4i Sport 2004 Kawasaki ZX-6R 2009 VW Jetta S |
#3
|
|||
|
|||
OK. I was really hoping it would be quick until I looked at the situation. I don't want any wires in view. So the center console has to come out as well? How hard is this? Thanks for your help!
|
#4
|
||||
|
||||
You do not want to take out the center console, very hard to do.. Just pop off the side panels and route the wires and equipment through
__________________
Robert 1994 740iL 2001 X5 4.4i Sport 2004 Kawasaki ZX-6R 2009 VW Jetta S |
#5
|
||||
|
||||
I mount the control module under/inside the center console
all you need is to remove the side panel and put it in there and run the wires from left seat and right seat to it. |
#6
|
|||
|
|||
OK. Thanks. I'll try that.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
|