4.6. exhaust tips on a 4.4

[TwinsPoppa]

Originally Posted by eax5

would you them and leave a lil bit on them or you willl just take the hole thing off

See the first link. He says to measure first.

[eax5]

but with part 13 or with out part 13#

[eax5]

cut with part 13# on or with out part 13# off

[TwinsPoppa]

With #13. His way is leave #13 on.

Place the ovals next to #13 and put them where you want it.

Mark the where the back of the ovals are on #13.

Remove exhaust, cut #13 at the mark. Put back exhaust.

Temporarily spot weld the tips to where you want them making sure its straight and where you wnat them.

Remove exhaust and finish welding.

Then buy those plastic rings that go around the tips to have a nice finished rear.

[eax5]

what number is that for the plastic rings that go on the rear

[eax5]

so then the best way to to do it its with 13#on im just trying to get the best look ... how fat out should i put the tips theres no pictures i could see to make it look kind of stock

[TwinsPoppa]

Originally Posted by eax5

so then the best way to to do it its with 13#on im just trying to get the best look ... how fat out should i put the tips theres no pictures i could see to make it look kind of stock

man-o-man ... there's a pic in the link that has the instructions. I'd probably have them stick out another inch or two (so they line up or go slightly past the pastic ring). Or search and see many pics of 4.8s/4.6s.

I think these are it for both sides. Don't take my word for it. Double-check.

51127010123
51127010124

[eax5]

do you now how far out do they go

[X Foomph]

Wish I had your patience Twins, it's admirable.

[TwinsPoppa]

Originally Posted by eax5

do you now how far out do they go

Okay ... see in the pic where the bumper meets the black plastic part (below the bumper) ... that's how far mine stick out. That's basically the same place as the top edge of the plastic ring you need to buy.

Are we about done here?