|
|
|
|
||||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
|
#1
06-02-2009, 09:52 AM
|
|||
|
|||
|
BMW 115030 tool
I'm try to looking for rought sketch or dimension for the pulley on water pump holder. As BMW special tool #: 11 5 030
|
|
#3
06-02-2009, 06:46 PM
|
|||
|
|||
|
No, it is not the 32mm wrench. It is the tool to hold the pulley not to move while you try to open the clutch fan nut
|
|
#4
06-02-2009, 07:09 PM
|
||||
|
||||
|
I use a steel chisel/punch and give a few wacks to the bolt on the fan clutch.
Worked on E30/E34/E36/E46/E53 for me. I thought of fabricating my own special tool a few times. I have the templates for the fan clutch somewhere. Will PM you if I find it.
__________________
|
|
#6
06-02-2009, 09:03 PM
|
||||
|
||||
|
Some pics attached.
The description of it: "Holder wrench for fan hub. Bolt Spacing 45mm. Applicable on the following engines: M10, M20, M30, M50, M52, M70, M73, S14, etc. 394mm in length." BMW P/N 83-30-0-491-046 MSRP $45.29 Quote:
Last edited by X5 Meister; 06-06-2009 at 10:23 PM.
|
|
#7
06-03-2009, 10:41 AM
|
||||
|
||||
|
X5 meister is a star as always .
you can make the tool by modifiying the bar from a speed clamp used by carpenters , should be available from diy stores . someone posted pics on this forum of a modified tool , if you click how to`s at top of page then X5 tips then E38 tips you`ll find info . could you take photos of your diy as the pics on other peoples diy`s are not very good , as you will see if you find them . ok , i found pic by searching water pump on the home page so here is what you need to make tool . Last edited by amacman; 06-03-2009 at 10:51 AM.
|
|
| Bookmarks |
|
|
|
|
Hybrid Mode
