Home Forums Articles How To's FAQ Register
Go Back   Xoutpost.com > BMW SAV Forums > X5 (E53) Forum
Arnott
User Name
Password
Member List Premier Membership Today's Posts New Posts

Xoutpost server transfer and maintenance is occurring....
Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management


 
 
LinkBack Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #23  
Old 08-14-2009, 05:12 PM
Member
 
Join Date: Apr 2005
Location: CA
Posts: 406
flyingmachine is on a distinguished road
I haven't seen an answer to OP's question. All those tools mentioned except the BMW special tool in prior replies will fail doing this job. The ball joint is not machine pressed in. It's pressed in while you tighten up those 2 bolts that hold it. So, it's still a pressure fit. Don't think about removing them by hands after removing those 2 bolts. Weasel pointed out one tip - make sure your socket has good grip on the bolt. They're very easy to be damaged. It sucks when that happens.

The BMW special tool is actually similar to slide hammer. I don't think you want to spend that money on this tool (a couple hundreds). Now, here is the tip you need. Cost of this solution could be $0 if you can rent them from local autozone. If you want to own the tools, get them from place like harborfreight for cheap. 2 things you need - slide hammer(like http://www.tooldesk.com/images/close...TD-3045_lg.jpg 3lbs one is good enough) and tied rod/pitman arm puller(like http://4x4icon.com/offroad/063007_st...2645_small.jpg).

Put the pitman arm puller as the attachment on your slide hammer. Leave thrust arm on the ball joint but remove 2 bolts holding ball joint to the steering knuckle. The just use the pitman arm puller on your slide hammer to hold between thrust arm and ball joint. Give it about 2 strikes and ball joint should come off. If the ball joint is heavily rusted, spray something like WD40 or PB Blaster and give it a few strikes. Leave it there to let the fluid penetrate thru. Give it a try after a couple minutes and it should do the trick.

Here is another tip. Make sure you get the alignment done after replacing the arm.

Last edited by flyingmachine; 08-14-2009 at 05:23 PM.
Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On





All times are GMT -4. The time now is 01:36 PM.
vBulletin, Copyright 2026, Jelsoft Enterprises Ltd. SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved. Xoutpost.com is a private enthusiast site not associated with BMW AG.
The BMW name, marks, M stripe logo, and Roundel logo as well as X3, X5 and X6 designations used in the pages of this Web Site are the property of BMW AG.
This web site is not sponsored or affiliated in any way with BMW AG or any of its subsidiaries.