Quote:
Originally Posted by TerminatorX5
i am at work, can not read SVG files, but a single wire from the light switch (S8) should go to pin 45 on the larger connector of the LCM (X10117). That wire tells LCM to activate the rear fog lights - I just don't remember where on the switch it goes to.
******
LCM module (A3), connector X38, pin 15 - left rear fog light - comes to pin 12 on X609
LCM module (A3), connector X12, pin 1 - right rear fog light - comes to pin 10 on X609.
*******
The left rear fog light is already wired from the LCM to the back of the car and is terminated at the connector X609, pin 12. the right rear fog llight is wired to the back of the car as well, and is terminated at the same connector, pin 10.
So, you do not have to run wires from the front of the car to the back, they are already there. You will have to run a single wire from the light switch to the LCM
|
so you are telling me that I have connector X609 for the trailer hitch pre-installed in the trunk, and as long as I plug a wire into each pin of the X609 connector, and run to each rear fog light (and ground each bulb), that I can do this without buying the Trailer harness?
Sorry to ask so many questions but you seem to be the guy with the resources and knowledge
12-20-2012, 11:03 AM
Threaded Mode
