|
|
|
|
||||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
03-07-2010, 03:18 PM
|
|||
|
|||
|
A/C clutch gap spec
 I need to know the gap specs for the A/C clutch to pulley? and the shims part no. inside the clutch. Does anyone know how tight the screw must be in able for clutch to engage properly? Thanks in advance.
|
| Sponsored Links | |
|
|
|
|
#3
03-08-2010, 11:21 AM
|
|||
|
|||
|
I got few washers from the auto parts store, the bolt is 6mm so you need to make sure it fits the bolt. The new washer was a bit larger, so I use a dremmel with grinding stone and remove some... to make it fit inside the clutch channel. Finally, one new washer +2 original and the gap is 3 sheets of paper wide...that's it. The AC finally works, the clutch engaged and air is cold again!!! Thanks you all!
  
|
|
| Bookmarks |
|
|
|
|
Linear Mode
