|
|
|
|
||||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
|
#1
01-10-2011, 10:21 AM
|
||||
|
||||
|
Hi wide, I did not, I just hooked it up, ran DIS on it, came clean, an after driving the car for a while the failsafe came back on, but I could still drive the car, something it wasn't doing with the older EGS tranny computer. now, when I run DIS, and the 0F error comes up, I can not seem to find info about it. is the help somewhere in the software of DIS that I am overlooking?
Thanks again, M. 
|
|
#2
01-10-2011, 11:02 AM
|
||||
|
||||
|
You might wnt to pm weasel.
__________________
04 X5 4.8is 76 2002 X-Pipe and Dinan Mufflers: www.youtube.com/watch?v=eWQh-izaTcY Pics http://www.flickr.com/photos/stevenb...7607968312734/
|
|
#4
01-10-2011, 02:00 PM
|
||||
|
||||
|
I would of course start with the test plan provided with that fault code, it helps test the system and usually provides usable results.
If the test plan doesn't help it is a matter of figuring out it the cause is in the valve body/solenoids, internal harness of transmission, other tranny parts, etc. This may end up being one of those cases where you end up spending less by getting professional diagnosis before throwing expensive parts at it.
__________________
"When you do things right, people won't be sure you've done anything at all" (Bender, futurama) You make something idiotproof, they'll make a better idiot You think professional is expensive, just wait until you pay for amateur. Never let your sense of morals prevent you from doing what is right. Examine what is said, not who speaks. X5 pics RIP 4.6is..... 2003 4.6is 
|
|
| Bookmarks |
|
|
|
|
Hybrid Mode
