|
Xoutpost server transfer and maintenance is occurring.... |
Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Blowing fuse #5
|
Sponsored Links | |
|
#2
|
|||
|
|||
OK. Finally got WDS to work on computer. Here's what I have so far:
1. Disconnected oil level sensor. Have short between pin 2 and pin 7 of connector x6053 (black on pin side) 2. Still blowing fuses. 3. Items connected with fuse 5, Oil level sensor, e-box fan, Generator 4. Items on x6053 pin side connector Pin 2 to oil level sensor, pin 7 to starter 5. According to WDS pin 2 on oil level sensor is ground, I get no ground. So there could be a broken wire for the ground and shorted wire some between pin 2 and pin 7. |
#3
|
|||
|
|||
I think I have it fixed now.
1.Found a problem with alternator wiring. Looks like it melted on something hot, near the alternator. Separated the wires and did continuity checks on oil level sensor, alternator, and e-box fan, all good. 2. I do not get a short across pin 2 and pin 7 of connector x6053. 3. Found the ground for pin 2 on the oil level sensor. 4. Fuse 5 did not blow when I turned the Key and the Park is highlighted on the dash board, before all the lights on the transmission indicator were just dim. Now to charge battery and see if it will start. I'll give you an update when it starts. Lucky me, I almost sent it the stealer for a new wiring harness. That would have cost big bucks. I'm only into this repair with new alternator (399) at advanced auto, new thermostat (91) at advanced auto, electrical tape, some fuses and a whole lot of time. What saved me was the BMW WDS. |
#4
|
||||
|
||||
good job. what browser and version are you using for wds.
__________________
04 X5 4.8is 76 2002 X-Pipe and Dinan Mufflers: www.youtube.com/watch?v=eWQh-izaTcY Pics http://www.flickr.com/photos/stevenb...7607968312734/ |
#5
|
|||
|
|||
Using wds V12 on internet explorer 32-bit. SVG viewer only works with 32-bit explorer and load java 32-bt. After you choose language, go to tech requirement and do systems test. That will tell you if explorer, SVG and Java are configured properly.
BTW: The X5 started. I probably need a new battery, but it started. Now to put it all back together. |
#6
|
||||
|
||||
i have both and it still wont work. where is tech thing to test?
__________________
04 X5 4.8is 76 2002 X-Pipe and Dinan Mufflers: www.youtube.com/watch?v=eWQh-izaTcY Pics http://www.flickr.com/photos/stevenb...7607968312734/ |
#7
|
|||
|
|||
1. mount wds iso or load wds dvd
2. open internet explorer 32-bit 3. go to file, open, (location of "index.htm" of wds 4. select language 5. you will be at model selection page 6. click on techn. requirements located lower right side 7. click on start system test located on the left page This should test your setup and let you know if its working, does java and svg test. Hope this helps. |
#8
|
||||
|
||||
oh im using the wds on this site. never mind.
__________________
04 X5 4.8is 76 2002 X-Pipe and Dinan Mufflers: www.youtube.com/watch?v=eWQh-izaTcY Pics http://www.flickr.com/photos/stevenb...7607968312734/ |
#9
|
|||
|
|||
Hi, may i politely ask, is fuse number 5 located in the glove box? As i might be having the same problem. Mu car wont crank and start, thanks
|
Bookmarks |
Tags |
alternator, battery light, fuses |
Thread Tools | |
Display Modes | |
|
|
|