pdc problem

spenburge · #1 12-27-2005, 06:44 PM

i have a problem with my pdc.it gives a constant sound when i put it into reverse for about 2 - 3 seconds and then goes off but the button still flashes constantly, has anyone got a clue on this one. also my radio just goes off with no specific time intervals and rarely switches its self back on only on long journeys im baffled can anybody help. thanx in advance.please see reply at bottom of page

Sponsored Links

powers1 · #2 12-27-2005, 06:46 PM

One of the PDC sensors is not connected properly.Check your connections.

X5Ghost · #3 12-27-2005, 06:56 PM

clean the sensores from any debris if so and make sure all are connected properly.

VANX5 · #4 12-27-2005, 09:13 PM

Same problem recently do a search, Mine worked after a couple of days again.

VanX5

RobC · #5 12-28-2005, 05:31 PM

I had the same PDC problem. Manual indicated it was a malfunction and the dealer had it in to fix it.

superH · #6 12-28-2005, 05:51 PM

I had this problem before and a connecter to one of the sensors was loose. Once it was plugged back in everything was normal.

powers1 · #7 12-30-2005, 02:24 PM

Spenburge,did you manage to sort out your PDC problem????Keep us updated!

spenburge · #8 12-30-2005, 09:32 PM

i checked all my sensors on the outside and cleaned them all off but the problem is still there. i read an article on how to get to the pdc unit and but when i came to do it i was rushed for time as i was due back in work and it seemed a bigger job than 1st thought .as it is under where the spare wheel goes.also im a bit confused on how to get to the connecters, do you have to take the bumpres off or do the pull out????????????

powers1 · #9 12-31-2005, 07:20 AM

Quote:

Originally Posted by spenburge

i checked all my sensors on the outside and cleaned them all off but the problem is still there. i read an article on how to get to the pdc unit and but when i came to do it i was rushed for time as i was due back in work and it seemed a bigger job than 1st thought .as it is under where the spare wheel goes.also im a bit confused on how to get to the connecters, do you have to take the bumpres off or do the pull out????????????

Unfortunately you have to remove the bumpers(see the articles on thís site)to access yõur PDC connectors from the inside of the bumper.DONT attempt to pry them out from the outside (without removing the bumper) as you will brake them!!!!
Check your PDC module unit first,the problem may be there!

Sponsored Links