2001 x5 4.4 starts then dies.....HELP!!!!

[SlickGT1]

Originally Posted by blakey2000

According to that manual I do need to adapt but no clearing is needed (all new components)


"This procedure is also necessary after replacing an ME 7.2 control module. However, the
adaptation values do not require clearing since they have not yet been established."

This would only apply to a new DME. Yours is not new.

[upallnight]

Originally Posted by SlickGT1

This would only apply to a new DME. Yours is not new.

@SlickGT1 Blakey 2000 swap out a new or rebuilt DME.

@Blakey2000 Do you still have the old DME?

Have you tried reinstalling some of the old parts?

[SlickGT1]

Originally Posted by upallnight

@SlickGT1 Blakey 2000 swap out a new or rebuilt DME.

@Blakey2000 Do you still have the old DME?

Have you tried reinstalling some of the old parts?

according to his first post,

I also replaced the DME with one from ecudoctors.com

so.... not sure if it would have cleared adaptations.

Blakey, what software do you have to work on the car. If you do not have GT1/DIS, we are all pissing in the wind.