Test Bench Setup

[nigwhyrito]

Okay been a while since i posted. Last post was about a place to grab power for front passenger side LCD. - thats done. Just need to source the oem sunvisors fabric.

Now i come to you again for help for my big project.

Test bench setup-is this possible?

1. Connect main wire harness to bench power supply and run
navigation radio, nav computer, Gps puck, dsp amp, tv module and nav board monitor, maybe my bluetooth module too, without damaging anything. I know it needs and I bus signal but it gets that from the car. I just want to pre wire everything in my house before I start the tedious proces of retrofitting my X with all that.


I know I've seen ebay posts where they have taken pics of the nav units working outside of the cars.

2. Then my next question: would any of the systems not being all the way connected in the car trigger a fatal fault to my X?

Say for example im not done the retrofit but i need to go to work. board monitor not installed yet or dsp amp not installed X will still start right no music for drive to work but no lights that have to be reset at stealer like airbag or nothing?