Software Help "SSS Progman"

[ninjabmw]

Originally Posted by Lexicon740iL

I finished installing the software suite from the Romanian Ebayer.

I plugged into the ODB and loaded up Carsoft as a first test.

It reads most of the modules and reset stored faults and service intervals fine.

Next I launched VM ware and tried out the SSS So I can set some key memory features.

I keep getting a error message after I try the initial scan for car Key Memory for my E53

It is necessary to use edic/icom for the connected vehicle.

Do I have my configurations screwed up

I launched INPA and It looks like it's working.....

Any suggestions?

In vm ware click VM then go down to snapshots and click sss 3 times faster configured icom and and it should work fine!

[Lexicon740iL]

Originally Posted by ninjabmw

In vm ware click VM then go down to snapshots and click sss 3 times faster configured icom and and it should work fine!

You da Man Ninja! Thanx.

I selected that setting in snapshot and launched. It worked fine.

But now everytime I launch it I have to select that option. Is there a way to save this setting so when I launch the virtual machine it loads 3x faster?

I'm new to VM ware.
My brother inlaw invited me to a conference/training seminar for VMWare in Dec. but I couldn't make it now I wish I had

[ninjabmw]

Originally Posted by Lexicon740iL

You da Man Ninja! Thanx.

I selected it that setting in snapshot and launched. it worked fine.

But now everytime I launch it I have to select that option. Is there a way to save this setting so when I launch the virtual machine it loads 3x faster?

I'm new to VM ware.
My brother inlaw invited me to a conference/training seminar for VMWare in Dec. but I couldn't make it now I wish I had

No bratha you just launch it normal it is default selected like that from now on so you dont need to worry man i hate that thing in SSS that makes you wait 1-2 minutes usually 5 for it to connect to ZKE. One more thing do you know anything about the 4x4 light being on just that light it has given me a headache i just get a error saying
90 degree wiper difference if you know anything would be nice if not dont go in detail. thanks again

[Lexicon740iL]

Originally Posted by ninjabmw

No bratha you just launch it normal it is default selected like that from now on so you dont need to worry man i hate that thing in SSS that makes you wait 1-2 minutes usually 5 for it to connect to ZKE. One more thing do you know anything about the 4x4 light being on just that light it has given me a headache i just get a error saying
90 degree wiper difference if you know anything would be nice if not dont go in detail. thanks again

Sounds like a Steering angle sensor error..... Have you done any work in the area where the sensor is mounted? It might need to be recalibrate or replaced.