|
||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Big problem ! please help asap
I got a big problem, every evening i put my start code on the control panel of my x5, this morning when i tried to start the car with my code, it didn't work, he didn''t accept the code i used ( wich is the correct one ) and after couple tries the alarm went off. afterwords i checked the users manual and there's an way to go past this, i'll write here what is written in the users manual ;
After three incorrect code entries, or 3. After ten minutes, start the engine.three attempts to start the engine without a code entry, the alarm will sound for 30 seconds on vehicles fitted with an alarm system. Deactivating the alarm in an emergency: If you have forgotten the code, proceed as follows: 1. Disconnect the battery, wait approx. 2 minutes, then reconnect it. Note that on vehicles with an alarm system, the alarm will sound 2. Set the ignition key to position 1: The time display will count down for the next ten minutes So i did all this and the engine works fine now, but the problem is my remote key locking doesn't work anymore, my alarm is also out of working order, and the interier light only front one doesn't work. but if i press the buttom to open the trunk, it works, but doors don't open/ close. Anyone has a problem like this before or can tell me where to look , ... ? i checked the fuses underneath the gloves department and there all good. ( the ones that work for the key locking. so i hope you guys can help because in 2 days i leave for holliday and i hope i can solve it. thanks in advance. |
| Bookmarks |
|
|
|
|