My turn to do valve seals

[Toothbrush]

Originally Posted by wsmeyer

I never did make friends with the AGA valve keeper tool. It's a marvelous bit of engineering but for most of the valves I found it too difficult to maneuver into position and if anything, took longer.

I went back to the old school long thin magnetic screwdriver method

I had issues with that tool, I figured out you have to use just the right amount of grease, make sure you go on properly aligned, and use a very quick on/off method. Then it was perfect 30sec max job to load it with new ones and then get the keepers on.

Glad you got it back in good working condition!