|
lol
The link I sent shows the seat system. The control **I THINK** actually sends encoded data via the wire 'S-BUS' which the control then decodes and activates each motor to move the right thing.
The thigh booster (aka seat depth) is at "M192" If you click on M192 you will find it lings to a picture of that motor. The connector for M192 is connector X14011
If you got a voltmeter onto pin 1 & 3 of X14011 you would like to see some voltage come on when you select that bolster to move. If you see voltage by no motion, maybe bad motor?
A start...GL
Last edited by ard; 06-30-2020 at 12:24 PM.
|
06-29-2020, 10:15 PM
Threaded Mode
