DVD Headrest Install.....

[acedeucy]

Originally Posted by Shumdit

Not to slam te vizualogic, but just as food for thought. I was installing the INvision system on a Saturday some months ago, and ran into a problem (not theirs, I did not read the diagram correctly). I called and left a message on Lawrence's cell phone, even though I did not expect to hear back until Monday. 10 minutes later he is calling me back and 10 minutes after that I am watching movies on the system. THAT IS SERVICE!!

Service with a smile that is!!! Another Satisfied Customer! Thanks for the kudos and Happy New Year!

-Law

[cpd1]

dbinc,

Thanks v much for the reply. I am pleased about the switched supply being the only one power feed required. Did you connect only that wire or the constant one as well into the switched feed?
Also, how easy were the seat back to remove, any broken clip to replace?
Thanks
again

C

[dbinc]

Shumdit: Post your install pictures.....

cpd1:

1. I connected both switch and constant.

2. Seat back was easy to remove, just pull back firmly from the top sides and then lift up. I did not break any clips or had to replace anything. It is pretty easy to install, just time consuming.

Any other questions, just let me know and I will try to get back to you as soon as I can.

[cpd1]

Thanks dbinc, really appreciate the help. Thinking of taking out the back of the center console to put the control unit and feed my ipod cable from the center storage. Any idea how easy it is to remove the back of the console? I was looking at it earlier but couldn't see any obvious ways/screws to take out
C

Originally Posted by dbinc

Shumdit: Post your install pictures.....

cpd1:

1. I connected both switch and constant.

2. Seat back was easy to remove, just pull back firmly from the top sides and then lift up. I did not break any clips or had to replace anything. It is pretty easy to install, just time consuming.

Any other questions, just let me know and I will try to get back to you as soon as I can.

[dbinc]

cpd1:

I removed the side carpet panels, once removed there will be 2 or 3 screws on each side(you will not miss it, you may not even have to remove these, just inspect how it is fastened). Then firmly pull back from the top or bottom, I forgot which one, but you will see where it is fastened.

This will also help, see link: http://www.realoem.com/bmw/partgrp.d...3&mospid=50043

[cpd1]

Thanks again dbinc. Had spent some time on the realOEM website to try to get a better idea. Shame they don't sell the technical manuals as they used too years ago, that had all the stuff!
I will let you know how I get on with it, placing the order for the hearest next week.
C

[dbinc]

cpd1: I agree with you on the technical manuals, I was looking all over, but non to be found. Good luck and post your install.

[amwi66]

Originally Posted by dbinc

Shumdit: Post your install pictures.....

cpd1:

1. I connected both switch and constant.

2. Seat back was easy to remove, just pull back firmly from the top sides and then lift up. I did not break any clips or had to replace anything. It is pretty easy to install, just time consuming.

Any other questions, just let me know and I will try to get back to you as soon as I can.

Sorry to hi-jack, but I need a constant pwoer supply tap as I'm installing a Dension Gateway 500, where did you get you constant power from?