|
||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
How do you replace a broken fog light assembly?
[/FONT] |
| Sponsored Links | |
|
|
|
|
#2
|
||||
|
||||
|
I think the link below is for a bulb replacement for the fog light, but i guess it might be helpful...
http://www.xoutpost.com/articles/x5/l...mw-x5-e70.html |
|
#3
|
|||
|
|||
|
question guys how or where is the fuse or relay for my 01 x-5? worked fine couple months ago....now nothing...gues it could be bulbs but my wife never uses them....i just dont see both out at the same time.
|
|
#4
|
|||
|
|||
|
ooops this is for my fog lights since we were on the subject....sorry
|
|
#5
|
|||
|
|||
|
I ordered the assembly from the dealer and after looking at the computer image of the fog light assembly I will be able to access the screws holding the assembly with the help of the above link. I will let you know after the light comes in next week if I was successful.
|
|
#6
|
|||
|
|||
|
Did you figure it out? I'm just trying to replace the bulb on the right side but can't get my hand in behind it - I think I may have to pop out the assembly? thanks
|
|
#7
|
||||
|
||||
|
^
Saw you other post, no you don't need to take out the whole assembly. Just follow the steps in the link above, wriggle your hand a bit, if your hands are big ask your girlfriend/wife if you can trust her
|
|
#8
|
|||
|
|||
|
The above link is all you need, with the addition of small hands to change the bulb. Be careful not to touch the bulb with you fingers or get any oils or grease on the surface.
To change the complete light bulb/lense assembly you need to use the link above and then remove (2) torx head screws with a 1/4" drive socket and a little finesse, I replaced the unit fairly quick. |
![]() |
| Bookmarks |
|
|
|
|