Successfully coded my E70

[xdm9mm]

I am trying to use a similar/same cable with INPA on my 2011 E70 with no luck at pulling the VIN or talking to any modules. I get the two black circles, but that is about it. I have read a bunch about pins 7 and 8... For a 2011 should I de-solder pin 8? I have read that ENET is now on pin 8...

I should probably just pony up for the cable from one-stop-electronics, but have to wait for the cable to show up and I am a very impatient person, since I have a soldering iron and am not afraid to use it. :-)

[Triple_O]

Originally Posted by xdm9mm

I am trying to use a similar/same cable with INPA on my 2011 E70 with no luck at pulling the VIN or talking to any modules. I get the two black circles, but that is about it. I have read a bunch about pins 7 and 8... For a 2011 should I de-solder pin 8? I have read that ENET is now on pin 8...

I should probably just pony up for the cable from one-stop-electronics, but have to wait for the cable to show up and I am a very impatient person, since I have a soldering iron and am not afraid to use it. :-)

I am about 99% sure your cable will not work even if you unsolder the pins. There are only a few vendors out there with quality cables that can be trusted 100% of the time. The cable you have is most likely junk and will only work on 2007 and older models. You might as well check the pins before you buy a new cable.