|
|
|
|
||||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
07-28-2015, 02:42 AM
|
|||
|
|||
|
Engine Fault - 4x4 System and DSC Failed!
Engine Fault Reduced Power Happens upon initial startup and stays in limp mode. - Temperature too high Happens upon startup (when sitting overnight) Had the auxiliary water pump replaced, still don't hear it come on. - 4x4 System and DSC Failed This will come on and the RPM wil drop ~1,100 RPM and will not accelerate. If I pull over and re-start it goes away and drives normal until the next time. I have noticed that this will only happen when I am not under acceleration and typically when going down a grade. Borrowed a friends Bavarain Technic cable and installed software and pulled a few codes, however I cannot connect to the Engine ECU. A12A A82E A830 5F77 6DCB 55C3 55D0 Connecting through my BT using Torque, I get the following codes P0003 P323f Any help would be greatly appreciated. 
|
| Sponsored Links | |
|
|
|
|
| Bookmarks |
|
|
|
|
Linear Mode
