With regards to the rear doors. If I use the GTO607 on the rears , it will mean throwing away the tweeters & crossover as I dont have holes for Tweeters (none that i have seen ).

Thats why i mentioned that would i not be in that case better off with GTO627 In the rear which is a 2-way speaker as well with the tweeter mounted on the bass dome. Then there is the option of turning the tweeter off according to taste


cooa99

yes, you are right about rear doors. but I wrote GTO607c for front doors only.
In rear - you can install GTO627, but GTO607c are higher class and same 2ohm. In Rear you can install tweaters,because only low frequency is coming from head-unit.
You have to install only 2ohm speakers with high sensitivity .

Cheers Ika,

With regrads to a line out converter attached to the head unit if powering a sub as well.
1) would adding a line out coverter to power a sub mean that I will loose a pair of speakers?. Well thats what a shop told me.


cheers

cooa99

Ok I got the speakers now i.e. front GTO607 & rear GTO625. I will also be buying Some cheap roofer's flashing Tape for sound deadning.

Ika, i hope the dash speakers are not wired from the front door speakers?


Already purchased Folding mirror's as well, so all I need now is a good couple of hours to do all the job in one go :).

I presume should i need to add an amp, that I can cut into all 4 speakers in the rear panel to feed an Amp that takes high speaker level inputs?

Also planing to build a sub enclosure to go in the below fuse box in the back. Whats are theadvantages of a fibreglas enclosure over MDF?

cooa99