Forum: X5 (E53) Forum
04-09-2019, 06:47 AM
|
|
Replies: 15
Views: 9,196
James,
It's good you checked the filter and...
James,
It's good you checked the filter and I'm glad you got it all sorted.
The original cause of my MAFS failure, also related to the air filter.....it had moisture on it.
Good luck with your...
|
Forum: X5 (E53) Forum
03-27-2019, 03:26 AM
|
|
Replies: 15
Views: 9,196
No worries James,
If the problem is very...
No worries James,
If the problem is very occasional, you should try to clean the sensor with a MAFS spray cleaner(I think that is what Jess and Dan need....ha ha!). Also, make sure your air...
|
Forum: X5 (E53) Forum
03-26-2019, 05:26 PM
|
|
Replies: 15
Views: 9,196
Hello James,
Yes, the computer reset...
Hello James,
Yes, the computer reset after the ignition was turned off. However, after about 5-10 minutes running, the warning re-appeared and the transmission problem re-occurred.....very...
|
Forum: X5 (E53) Forum
12-22-2016, 06:00 PM
|
|
Replies: 180
Views: 75,143
Thanks wpoll,
Yes, I knew about the 2 year...
Thanks wpoll,
Yes, I knew about the 2 year warning clock for the brake fluid change.........I just got a 'little' late in performing doing the job! It just goes to show that you should follow the...
|
Forum: X5 (E53) Forum
11-29-2016, 07:07 PM
|
|
Replies: 180
Views: 75,143
Hello All,
My X5 (165,000km) experienced...
Hello All,
My X5 (165,000km) experienced the intermittent, combined brake light and DSC light a couple of months ago. This lead to the occasional disengagement of the 4WD and engine limp mode....
|
Forum: X5 (E53) Forum
11-03-2016, 05:01 PM
|
|
Replies: 102
Views: 25,161
Yes Ricky Bobby, I have the aluminium running...
Yes Ricky Bobby, I have the aluminium running boards. But, there is no need to touch them or the plastic rivets.
If you are only 'inspecting' the brake lines and applying anti-rust spray, you don't...
|
Forum: X5 (E53) Forum
11-03-2016, 02:59 AM
|
|
Replies: 102
Views: 25,161
FYI........
I just checked my brake lines...
FYI........
I just checked my brake lines and junctions without having to remove the very large black plastic shield used to cover the fuel filter and tanks.
All the lines were clean and...
|
Forum: X5 (E53) Forum
11-03-2016, 02:43 AM
|
|
Replies: 33
Views: 14,284
|
Forum: X5 (E53) Forum
04-04-2016, 06:23 AM
|
|
Replies: 27
Views: 19,068
Guys,
Read the thread on this site titled...
Guys,
Read the thread on this site titled "CV BOOT REPLACED IN 30 MINUTES", and follow the instructions from "dville" in Post 36, page 4.......
Copied below, FYI:
Nothing to remove...
|
Forum: X5 (E53) Forum
04-04-2016, 05:39 AM
|
|
Replies: 444
Views: 249,233
|
Forum: X5 (E53) Forum
03-24-2016, 07:04 PM
|
|
Replies: 33
Views: 14,284
Thanks for your input, everyone.
Just to...
Thanks for your input, everyone.
Just to draw a conclusion to his thread, my conclusions are:
1. As I live in a beachside suburb (about 500 metres from the ocean) there is regularly...
|
Forum: X5 (E53) Forum
03-23-2016, 09:56 PM
|
|
Replies: 33
Views: 14,284
Hello TiAgX5,
The driveway has a very...
Hello TiAgX5,
The driveway has a very slight (2-3deg.) slope. When I park the car, it actually sits "nose up".
I think it has been slowly rusting away for around 4-5 years. Once the rust...
|
Forum: X5 (E53) Forum
03-23-2016, 08:47 PM
|
|
Replies: 33
Views: 14,284
Hello 4.8isX5,
Mine is a 2004 3.0i with a...
Hello 4.8isX5,
Mine is a 2004 3.0i with a sports pack. I've owned the car since new, and it has never been in any accidents. It has done 160,000 klm and it is in very good order (no signs of rust...
|
Forum: X5 (E53) Forum
03-23-2016, 06:09 PM
|
|
Replies: 33
Views: 14,284
|
Forum: X5 (E53) Forum
03-23-2016, 06:53 AM
|
|
Replies: 33
Views: 14,284
WARNING....SPLASH SHIELD CAUSES RUST TO SUB-FRAME!
What a disaster.....!
A couple of weeks ago, I accidentally dropped a hose clip down into the engine bay. Looking from the top of the engine bay, I couldn't find it anywhere! So, I decided to look...
|
Forum: X5 (E53) Forum
03-09-2016, 08:29 PM
|
|
Replies: 15
Views: 9,196
Trans. Failsafe Prog Warning and MAF sensor
Just a quick note re when the TRANSMISSION FAILSAFE PROGRAM warning message comes on the check control panel on the dashboard!
I had this failure warning appear last week. The transmission went...
|
Forum: X5 (E53) Forum
06-10-2013, 10:00 PM
|
|
Replies: 97
Views: 258,057
Hello ake53,
As you will see from Pics 10...
Hello ake53,
As you will see from Pics 10 and 11 of Brian's first post, the lock actuator is a 'sealed unit'.
So, if you can still open/close and lock the door with the central locking, the...
|
Forum: X5 (E53) Forum
05-26-2013, 06:05 AM
|
|
Replies: 97
Views: 258,057
Hi again 215kid,
Just follow Brian's post...
Hi again 215kid,
Just follow Brian's post with pics exactly and you should be able to open the door. Remember to make a steel rod with a 90 deg turn at the top and bottom as shown in his pics.......
|
Forum: X5 (E53) Forum
05-25-2013, 06:42 PM
|
|
Replies: 97
Views: 258,057
Hello 215kid,
Yes, the coathanger method to...
Hello 215kid,
Yes, the coathanger method to open the door lock should work, whether the problem is a broken carrier or simply a dirty/gummed-up mechanism.
Either way, you will probably have...
|
Forum: X5 (E53) Forum
05-20-2013, 01:37 AM
|
|
Replies: 97
Views: 258,057
|
Forum: X5 (E53) Forum
01-15-2013, 06:34 PM
|
|
Replies: 0
Views: 4,894
X5 glove box lock fix
How I fixed a faulty glove box latch on my BMW X5 e53.
Hi guys, Just had some great success on finally fixing a faulty glove box latch on my BMW X5 e53, 2004 model (not the motorised version).
...
|