![]() |
New Member E53 Owner
Good day people! I've been reading this forum for quite some time now. I've recently been gifted a 2001 4.4i E53 Black/Black comfort seats 192k miles (Black Betty 3). I love the vehicle, especially since it's free!:D
Got the car in NYC, it's been an NYC car all it's life. Previous owner was a female that only wanted to drive a BMW for the name. She drove it regularly from the city to school upstate. She traded it in for a malibu :dunno:. I'm a dealer, my brother works at a the dealership she traded it into and gifted it to me. I had been driving his 2013 X5 5.0i, which was a blast, so I gladly accepted. I hadn't known what I gotten myself into, done my own checks on fluids, changed the spark plugs, added some lucas synthetic oil and gas treatment and got on the road to Georgia! I got on the road and all went well, until I switched into sport mode and overtook a slow moving car and the i85 and Black Betty slowed to a crawl 132 miles away from home. "Engine Failsafe Mode" popped up on the dash, could't go over 25 MPH. The few mechanics I could make it to in SC told me it could be huge or tiny problems. Got a code for the cam shaft position sensors, changed those on the spot to no avail. Eventually, I called AAA and got it towed home the rest of the way. So I'm stuck at a cross roads, do I keep the vehicle do an engine swap, or count my losses on a free car (absolutely none) and sell it for parts as I've seen '06 4.6i's for sale around $3500 low miles in the auction? My intentions for her were to customize it to my liking and use her to tow my cars home from auctions out of state. Is that possible or far-fetched thinking? Thanks alot for all the information you guys share on this forum! A true wealth of knowledge here. Nice to meet ya! |
Welcome!
Does the engine run at all? |
Quote:
The engine does run a bit, I just took a video, looking for a way to upload it now. Basically the engine starts and revs between 0 & 1500 all on it's own. Then if you don't gas it, it dies. |
I'd take the engine apart and see what happened. Sounds like a sensor failure or a big vacuum leak. Scan it with an ODBII reader if possible and let us know if you find any codes— that might clue us in on what happened with your engine.
|
Quote:
82-drive by wire throttle position montering 71-camshaft position sensor cycle 1-3 72- cycle 5-8 8c-map control thermastat circut control 22-cam shaft vanos control cucle 5-8 62-evap emmission systum purge valve 73 air mass sensor Problem is, I don't have funds to waste but I would like to get her running. Would a swap or repair seem best? |
Sounds like you don't do your own repair work, correct?
|
Correct, I don't, but I am a DIYer. I do small repairs & big ones as long as there's a video on youtube.
Changing the sensors are basically plug and play, within my scope of understanding. But I was concerned it was a timing chain guide problem. Sent from my SM-G930T using Tapatalk |
Quote:
|
Quote:
|
Hm, looks like your throttle body might have called it quits— that alone can throw you into engine failsafe. I'd start with that and move on to the other sensors afterwards.
|
| All times are GMT -4. The time now is 08:23 PM. |
vBulletin, Copyright 2026, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved.