Transmission Mount Tool
 

I have an '06 3.0 and it's time to change the transmission mount bushing after 266,000 miles. Just received the bushing, but the only tool I can find to replace it is $129. For a tool I'll only use once, so, before I buy one I thought I'd ask if anyone in the SF Bay Area has one they'd rent or sell me? Otherwise I'll have to buy one and try and sell it. TIA

I haven't tried it, but I'd first try to do it with a universal ball joint kit that you can borrow from your local auto parts store. Usually, with a little creativity, you can figure out a way to get it done. I replaced all the subframe bushings on my e46 that way. It wasn't the best tool for the job, but it worked.

AM.

Similar thought: the bushing press for the rear ball joint worked perfectly to press new bushings into the tension struts. I had to use a smaller diameter bolt like 1/2" vs. 14mm the tool came with.

They can be found for ~$70 on Alibaba if you want to go that route

Thanks. I'll take a look.

I didn't have any luck there. Lots of other tools.

You can usually cobble something together. Here are a couple of examples on my E61 and E70. First was using a "rent-a-tool" from Oreilly and the second I went and bought a bushing tool from Harbor Freight (I forget the cost, but it wasn't much). E61 was done in place and the E70 was done on a trans jack.

I know the setups look goofy... but accomplished their tasks in a matter of minutes. :dunno:

E61

Attachment 81998

Attachment 81999

Attachment 82000

Attachment 82001

E70

Attachment 82002

if anyone finds the tool on aliexpress, please post a link. :)

If it works, it works!

ditto