Originally Posted by richirich

:D I just replaced my front and rear roundels!

The rear roundel is a glue on and a bit$H to get off. Once you remove it, you will need a new one! Be very careful removing it. I had a buddy slightly pry it while I ran a very sharp razor blase around the edges to break the glue seal. To replace I cleaned all the old glue off and cleaned it......once that is off you will need I believe it was an 8mm hex type screwdriver ( I just butchered what the name of the tool is). Take off base, clean, tighten back on and apply new roundel. Done!

I hope this helps!:D

RR

Originally Posted by KingCon

I popped it off with a credit card, it has two prong type nipples that attach it to the car. The new roundel should have them also, pop it right in. Heads up, the steering wheel roundel doesn't come off, as bad as I wanted to replace it to match the new set....it's part of the air bag and could pose a hazard if deployed.

Good luck.